Access Control Fiber Hardware and Installation

The scope of this project is the addition of Head-End Access Control System (ACS) security devices at the Tampa Convention Center at each first-floor meeting/ballroom doors. Project will be installation of ACS wiring to prepare for the replacement and upgrade of the public facing doors of the first floor. Due to wall fabric around doors, fabric repairs may be necessary after installation if cuts are needed to pull cables. Wiring will not be terminated into access readers at this time. This is the first phase of several for a broader project. Expected hardware needs: 31 x Door Wiring for ACS and Spare Power Cable 06 x Door Wiring for Monitoring 05 x ACS Head End (HE) Enclosure with power supplies 05 x Genetec SY-LP1502 Mercury Intelligent Controller 11 x Genetec SY-MR52-S3 Mercury MR52 2-reader interface module 01 x Genetec SY-MR16IN-S3 Mercury MR16IN 16-input Monitor Module Cables will be run from intermediary distribution frames on the 2nd/maintenance level above the doors and dropped downward and capped/coiled right above doorway (inside wall) for storage until TCC is ready to utilize the cables. There are a total of 31 doors/drops.