EXTRA-71327 - USA (Lebanon, Missouri) - Aero Landing Lift Station Equipment Supplies - Deadline June 30,2026

(1) Vendor needs to provide aero landing lift station equipment supplies to the government authority located in Lebanon, MO. – Pump:1. Vertical Discharge 1 ¼” NPT2. Liquid Temperature Continuous: 120 °F (48 °C) Intermittent: 140 °F (60 °C)3. Volute Cast Iron ASTM A–48, Class 304. Motor Housing Cast Iron ASTM A–48, Class 305. Seal Plate Cast Iron ASTM A–48, Class 306. Impeller Design: 12 vanes, vortex with vanes on back side, dynamically balanced.7. Material: Cast iron ASTM A–48, Class 308. Radial Cutter: Hardened 440C, stainless steel, hardness Rockwell C–55 Shaft 420 series stainless steel hardware stainless steel o–rings Buna–N.9. Paint air dry enamel, water based.10. Seal design: Double seal, oil lubricated. Material – ceramic stationary part, carbon ring seal and exclusion in the rotating part, and silicon–silicon in the secondary (pump) seal. Buna–N elastomer and stainless steel spring.11. Cord Entry 30 ft of neoprene cored, sealed against moisture.12. Bearings ball, single row, oil lubricated.13. Motor single phase: Permanent split capacitor, 230 volts, 60 Hz, 3500 RPM, oil–filled, with overload protection in motor. Class F insulation.– Panel:1. Enclosure Type 4X polycarbon.2. Circuit breaker For pump and control circuit.3. Contactor Definite purpose.4. HOA switch Three position toggle HP rated5. Alarm switch Three position toggle HP rated6. Run light Amber neon pilot light7. Alternating relay With lead selector switch(2) All the questions must be submitted no later than June 25, 2026.